BackupPVC Configuration for Data Movement Backup

BackupPVC is an intermediate PVC to access data from during the data movement backup operation.

In some scenarios users may need to configure some advanced options of the backupPVC so that the data movement backup operation could perform better. Specifically:

• For some storage providers, when creating a read-only volume from a snapshot, it is very fast; whereas, if a writable volume is created from the snapshot, they need to clone the entire disk data, which is time consuming. If the backupPVC’s accessModes is set as ReadOnlyMany, the volume driver is able to tell the storage to create a read-only volume, which may dramatically shorten the snapshot expose time. On the other hand, ReadOnlyMany is not supported by all volumes. Therefore, users should be allowed to configure the accessModes for the backupPVC.
• Some storage providers create one or more replicas when creating a volume, the number of replicas is defined in the storage class. However, it doesn’t make any sense to keep replicas when an intermediate volume used by the backup. Therefore, users should be allowed to configure another storage class specifically used by the backupPVC.

Velero introduces a new section in the node agent configuration ConfigMap (the name of this ConfigMap is passed using --node-agent-configmap velero server argument) called backupPVC, through which you can specify the following configurations:

• storageClass: This specifies the storage class to be used for the backupPVC. If this value does not exist or is empty then by default the source PVC’s storage class will be used.

• readOnly: This is a boolean value. If set to true then ReadOnlyMany will be the only value set to the backupPVC’s access modes. Otherwise ReadWriteOnce value will be used.

The users can specify the ConfigMap name during velero installation by CLI: velero install --node-agent-configmap=<ConfigMap-Name>

A sample of backupPVC config as part of the ConfigMap would look like:

{
    "backupPVC": {
        "storage-class-1": {
            "storageClass": "backupPVC-storage-class",
            "readOnly": true
        },
        "storage-class-2": {
            "storageClass": "backupPVC-storage-class"
        },
        "storage-class-3": {
            "readOnly": true
        }        
    }
}

Note:

• Users should make sure that the storage class specified in backupPVC config should exist in the cluster and can be used by the backupPVC, otherwise the corresponding DataUpload CR will stay in Accepted phase until timeout (data movement prepare timeout value is 30m by default).
• If the users are setting readOnly value as true in the backupPVC config then they must also make sure that the storage class that is being used for backupPVC should support creation of ReadOnlyMany PVC from a snapshot, otherwise the corresponding DataUpload CR will stay in Accepted phase until timeout (data movement prepare timeout value is 30m by default).
• If any of the above problems occur, then the DataUpload CR is canceled after timeout, and the backupPod and backupPVC will be deleted, and the backup will be marked as PartiallyFailed.